|
No clicks generated
(PRO Models)
|
- Gain setting too low, increase gain to maximum and retry
- Microphone jack not firmly plugged in
- Microphone not positioned properly, place in front of audio source and retry.
- Try substituting microphone with a known working unit. Monitor LEDs for activity.
- Try puffing hard as if trying to blow out 40 candles, looking for LED activity, if none recheck all the above and notify LaZee Tek support.
- See also Clicking Verification procedure is very helpful in determining proper operation of the equipment.
|
|
Unwanted clicks generated (PRO models)
|
- Gain setting too high for existing background noise, decrease gain.
|
|
No Cursor movement
|
- Unplug USB cable, wait 10 seconds and reconnect
- Cursor position possibly off to the side of screen & not visible
- Recheck above and notify LaZee Tek support.
|
|
No Cursor visable
|
- Cursor is just off the edge of the screen, move the mouse in a circular motion to return it to the viewable screen. Try using a standard mouse to aid in “finding” the cursor.
- Cursor Wrapping programs are available that wrap the cursor back around to the other side of the screen.
|
|
Cursor Movement Erratic or Uncontrollable
|
- This is normally caused by loose mounting or in the case of a Body Sensor, oriented incorrectly. The Cursor Verification procedure is helpful in determining proper operation of the equipment.
|
|
UP/Down is OK, but L/R doesn’t work
|
- Ensure unit is tilted L & R and not rotated. Rotational movements to the left and right are not intended to move the cursor.
|
